{{ name }}
Art-nr {{ combinedCodeWithHighlight }}
Artikelnummer:
EAN/GTIN:
Tillverkarens nummer:
HiPer-Drill grundelement 12,5 mm
Art-nr: 231605 12,5
Artikelnummer:
- Utförande: 3×D
- Skaft: ISO 9766
- Borranvändning: kräver kryssborrning; kräver paketborrning; kräver snedställd utgång; kräver snedställd borrstart
- Invändig: ja
Produktdetaljer
Tekniska data
| Serie | HiPer-Drill | |
| Utförande | 3×D | |
| Skaft | ISO 9766 | |
| Borranvändning | kräver kryssborrning; kräver paketborrning; kräver snedställd utgång; kräver snedställd borrstart | |
| Antal skär Z | 2 | |
| Invändig | ja | |
| Diameterområde Dc | 12,5 mm - 12,99 mm | |
| Effektiv längd L1 | 39 mm | |
| Skaftdiameter Ds | 16 mm | |
| Skaftlängd Ls | 48 mm | |
| Spännskruv | 231999 6IP (0,4 Nm) | |
| totallängd L | 109 mm | |
| Produktslag | Vändskärsborrar |
Identifieringsnummer och klassificeringar
| Artikelnummer | 231605 12,5 | |
| EAN/GTIN | 4045197716156 |
Benämning
Version:
- Very high feed rates and maximum performance due to optimally matched geometries and materials.
- Precise positioning of the cutter insert due to Vee insert seating and secure clamping by the centre bore.
- High concentricity when assembled. (For holes up to IT9 accuracy)
- Shank support for optimum stability in operation.
Created by an additive procedure.
Application:
For stationary and rotating use. For holes up to IT9 accuracy.
Note:
The insert screw must be replaced after every fifth change of cutter insert.
Further sizes up to ⌀ 50.99 mm available on request.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
Further sizes up to ⌀ 50.99 mm available on request.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.