{{ name }}
Prekės Nr. {{ combinedCodeWithHighlight }}
Prekės numeris:
EAN / GTIN:
Gamintojo numeris:
Pjovimo diskas metalui stambiadantis HZ 125X6 mm
Prekės Nr.: 176000 125X6
Prekės numeris:
Spustelėkite, kad padidintumėte vaizdą
Spustelėkite, kad padidintumėte vaizdą
Laikiklius diskams ⌀ 20 − 63 mm žr. Nr. 345510 / 345555
Spustelėkite, kad padidintumėte vaizdą
Spustelėkite, kad padidintumėte vaizdą
Spustelėkite, kad padidintumėte vaizdą
Spustelėkite, kad padidintumėte vaizdą
- Tool material: HSS
- Standard: DIN 1838
Produkto detalės
Techniniai duomenys
| ⌀ | 125 mm | |
| Thickness | 6 mm | |
| Danga | be dangos | |
| Tool material | HSS | |
| Standard | DIN 1838 | |
| Bore ⌀ | 22 mm | |
| No. of teeth Z | 40 | |
| Through-coolant | ne | |
| Type of product | Pjovimo diskas |
Identifikavimo numeriai ir klasifikacijos
| Produkto numeris | 176000 125X6 | |
| EAN / GTIN | 4045197244697 |
Informacinė pritaikymo lentelė
N
800
N
600
P
37
P
22
P
20
P
15
M
11
M
11
K
27
N
400
Aprašymas
Version:
All blades are hollow ground to give side clearance. All sizes with 200 mm ⌀ and very thin blades have a bore collar for stabilisation. Accuracy, tooth form, and side clearance grinding according to DIN 1840.
DIN 1838 C coarse-toothed with curved form C. High performance tooth pitch (HZ) with high teeth and lower finishing teeth. The roughing tooth is 0.15 – 0.30 mm higher than the finishing tooth and is chamfered at both tooth corners. In this way both types of teeth share the cutting work.
DIN 1838 C coarse-toothed with curved form C. High performance tooth pitch (HZ) with high teeth and lower finishing teeth. The roughing tooth is 0.15 – 0.30 mm higher than the finishing tooth and is chamfered at both tooth corners. In this way both types of teeth share the cutting work.
Application:
Particularly suitable for cutting workpieces with low to medium tensile strength. High cutting performance due to the chip breaking tooth form.
Please note: If the component is not cut through, but only cut into, the bottom of the cut will have an additional slot due to the projecting high tooth.
Please note: If the component is not cut through, but only cut into, the bottom of the cut will have an additional slot due to the projecting high tooth.
Note:
The concentricity and axial run-out values are considerably better than the figures according to DIN 1840, in some cases by up to 50 %.