{{ name }}
Article no. {{ combinedCodeWithHighlight }}
Article code:
EAN / GTIN:
Manufacturer number:
Solid carbide drill plain shank DIN 6535 HA 180° 13,5 mm
Article no.: 122793 13,5
Article code:
Click to enlarge image
Plain shank DIN 6535 HA
Click to enlarge image
Click to enlarge image
Cutter with corner chamfer
Click to enlarge image
Click to enlarge image
- Tool material: Solid carbide
- Version: 5×D
- Point angle: 180
- Shank: DIN 6535 HA to h6
- Use for drilling: limited convexity; limited cross-drilling; limited oblique spot drilling
Product details
Technical Data
| Nominal ⌀ DC | 13.5 mm | |
| Coating | TiAlN | |
| Tool material | Solid carbide | |
| Standard | Manufacturer’s standard | |
| Version | 5×D | |
| Tolerance nominal ⌀ | m7 | |
| Number of cutting edges Z | 2 | |
| Point angle | 180 degrees | |
| recommended maximum drilling depth L2 | 54.8 mm | |
| Shank | DIN 6535 HA to h6 | |
| Use for drilling | limited convexity; limited cross-drilling; limited oblique spot drilling | |
| Through-coolant | yes, with 25 bar | |
| Pilot drill required | yes, pilot drill | |
| Semi-Standard | yes | |
| Flute length Lc | 75 mm | |
| Overall length L | 122 mm | |
| Shank ⌀ Ds | 14 mm | |
| Shank tolerance | h6 | |
| Feed f in steel < 900 N/mm2 | 0.16 mm/rev. | |
| Colour ring | green | |
| Type of product | Jobber drill |
Identification numbers & Classifications
| Article number | 122793 13,5 | |
| EAN / GTIN | 4045197745323 |
Application Table
P
85
P
75
P
60
P
50
M
45
K
90
Description
Version:
Special point geometry for generating 180° flat-bottomed holes. Low radial forces even when spot drilling on faces with up to 15° slope. Flute geometry for optimum chip evacuation. With 4 guide chamfers to stabilise the drill in the hole.
Advantage:
The 180° point angle permits drilling and counterboring in a single operation.
Recommendation:
When using the solid carbide 180° drill it is absolutely essential for process reliability:
- When spot drilling on flat surfaces to drill a pilot hole 1×D using pilot drill No. 122736.
- When spot drilling on sloping surfaces up to max. 15° : reduce the feed rate f to 25% of the stated value. After spot drilling, the normal feed rate value can be used.
Tip:
Spaangroeflengte LC = L2 + 1,5 × DC.
Vorm HB en HE voor dezelfde prijs als HA leverbaar.
Vorm HB: met nr. 122793 + 129100HB bestellen.
Vorm HE: met nr. 122793 + 129100HE bestellen.
180°-VHM-boor voor aluminiumbewerking op aanvraag leverbaar.
Niet geschikt voor het maken van verzinkingen voor cilinderkopbouten volgens DIN974-1.
Vorm HB en HE voor dezelfde prijs als HA leverbaar.
Vorm HB: met nr. 122793 + 129100HB bestellen.
Vorm HE: met nr. 122793 + 129100HE bestellen.
180°-VHM-boor voor aluminiumbewerking op aanvraag leverbaar.
Niet geschikt voor het maken van verzinkingen voor cilinderkopbouten volgens DIN974-1.