{{ name }}
Réf. {{ combinedCodeWithHighlight }}
Référence:
EAN / GTIN:
Réf. fabricant:
Élément de base HiPer-Drill 22 mm
Réf.: 231617 22
Référence:
- Exécution: 10×D
- Queue: ISO 9766
- Application de perçage: Perçage transversal sous condition; Perçage en paquet sous condition; Sortie en oblique sous condition; Pré-perçage en oblique sous condition
- Arrosage interne: oui
Détails du produit
Caractéristiques techniques
| Série | HiPer-Drill | |
| Exécution | 10×D | |
| Queue | ISO 9766 | |
| Application de perçage | Perçage transversal sous condition; Perçage en paquet sous condition; Sortie en oblique sous condition; Pré-perçage en oblique sous condition | |
| Nombre de dents Z | 2 | |
| Arrosage interne | oui | |
| Plage ⌀ Dc | 22 mm - 22,99 mm | |
| Long. utile L1 | 230 mm | |
| ⌀ queue Ds | 25 mm | |
| Long. queue Ls | 56 mm | |
| Vis de serrage | 231999 10IP (3,3 Nm) | |
| Longueur totale L | 320 mm | |
| Type de produit | Forets à plaquettes |
Numéros d’identification et classifications
| Référence article | 231617 22 | |
| EAN / GTIN | 4045197869036 |
Description
Version:
- Very high feed rates and maximum performance due to optimally matched geometries and materials.
- Precise positioning of the cutter insert due to Vee insert seating and secure clamping by the centre bore.
- High concentricity when assembled.
- Shank support for optimum stability in operation.
Polished flutes.
Application:
For stationary and rotating use. For holes up to IT9 accuracy.
Note:
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
Further sizes up to ⌀ 50.99 mm available on request.
The insert screw must be replaced after every fifth change of cutter insert.
Reduce feed rates f by 10 % and vc values by 30 %.
For process reliability when using the drill, initial pilot drilling to 1.5×D with the drill No. 231600 with the same cutter insert size and type is necessary. The generation of a pilot hole improves process reliability.
For optimum stability, clamp the drill so the overhang is as short as possible.
Further sizes up to ⌀ 50.99 mm available on request.
The insert screw must be replaced after every fifth change of cutter insert.
Reduce feed rates f by 10 % and vc values by 30 %.
For process reliability when using the drill, initial pilot drilling to 1.5×D with the drill No. 231600 with the same cutter insert size and type is necessary. The generation of a pilot hole improves process reliability.