{{ name }}
Artikkelnr. {{ combinedCodeWithHighlight }}
Artikkelkode:
EAN / GTIN:
Manufacturer number:
HiPer-Drill stomme 3×D 19 mm GARANT
Article no.: 231605 19
Artikkelkode:
- Version: 3×D
- Shank: ISO 9766
- Use for drilling: limited cross-drilling; limited drilling through a stack; limited drilling with oblique exit; limited oblique spot drilling
- Through-coolant: yes
Produktinformasjon
Technical Data
| Series | HiPer-Drill | |
| Version | 3×D | |
| Shank | ISO 9766 | |
| Use for drilling | limited cross-drilling; limited drilling through a stack; limited drilling with oblique exit; limited oblique spot drilling | |
| Number of cutting edges Z | 2 | |
| Through-coolant | yes | |
| Dia. range Dc | 19 mm - 19.99 mm | |
| Reach L1 | 60 mm | |
| Shank ⌀ Ds | 25 mm | |
| Shank length Ls | 56 mm | |
| Clamping screw | 231999 9IP (2.2 Nm) | |
| Overall length L | 146 mm | |
| Type of product | Indexable drill |
Identification numbers & Classifications
| Artikkelkode | 231605 19 | |
| EAN / GTIN | 4045197602800 |
Beskrivelse
Version:
- Very high feed rates and maximum performance due to optimally matched geometries and materials.
- Precise positioning of the cutter insert due to Vee insert seating and secure clamping by the centre bore.
- High concentricity when assembled. (For holes up to IT9 accuracy)
- Shank support for optimum stability in operation.
Application:
For stationary and rotating use. For holes up to IT9 accuracy.
Note:
The insert screw must be replaced after every fifth change of cutter insert.
Further sizes up to ⌀ 50.99 mm available on request.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
Further sizes up to ⌀ 50.99 mm available on request.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.