{{ name }}
Réf. {{ combinedCodeWithHighlight }}
Référence:
EAN / GTIN:
Réf. fabricant:
élément de base HiPer-Drill 16 mm
Réf.: 231615 16
Référence:
- Exécution: 8×D
- Queue: ISO 9766
- Application de perçage: Perçage transversal; Perçage de paquets; Sortie de perçage en biais; Pré-perçage en oblique sous condition
- Arrosage interne: oui
Détails du produit
Caractéristiques techniques
| Series | HiPer-Drill | |
| Exécution | 8×D | |
| Queue | ISO 9766 | |
| Application de perçage | Perçage transversal; Perçage de paquets; Sortie de perçage en biais; Pré-perçage en oblique sous condition | |
| Number of cutting edges Z | 2 | |
| Arrosage interne | oui | |
| Dia. range Dc | 16 mm - 16.99 mm | |
| Reach L1 | 136 mm | |
| Shank ⌀ Ds | 20 mm | |
| Shank length Ls | 50 mm | |
| Clamping screw | 231999 8IP1 (1.2 Nm) | |
| Overall length L | 212 mm | |
| Type de produit | Forets à plaquettes |
Numéros d’identification et classifications
| Référence article | 231615 16 | |
| EAN / GTIN | 4045197603210 |
Description
Version:
- Very high feed rates and maximum performance due to optimally matched geometries and materials.
- Precise positioning of the cutter insert due to Vee insert seating and secure clamping by the centre bore.
- High concentricity when assembled.
- Shank support for optimum stability in operation.
Application:
For stationary and rotating use. For holes up to IT9 accuracy.
Recommendation:
Drill the pilot hole.
Note:
Further sizes up to ⌀ 50.99 mm available on request.
The insert screw must be replaced after every fifth change of cutter insert.
reduce vf values by 20 %.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
For process reliability when using the drill, initial pilot drilling to 1.5×D with the drill No. 231600 with the same cutter insert size and type is necessary. The generation of a pilot hole improves process reliability.
The insert screw must be replaced after every fifth change of cutter insert.
reduce vf values by 20 %.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
For process reliability when using the drill, initial pilot drilling to 1.5×D with the drill No. 231600 with the same cutter insert size and type is necessary. The generation of a pilot hole improves process reliability.